did u guys run truck when drilling? or did you get someone to hold powerful shopvac and magnet by spot where u r drilling?

 

Nope, I let the motor sit overnight until it was cold. I didn't want to chance snapping a bit or tap and hearing my turbo for one last time. I figured if something did happen, I still could disassemble everything to get the pieces out.

I used a telescoping pen magnet to fish out the filings as I went. Thepen magnet fit right into the hole.

 

yeah but if you look at picture where we should drill the turbo flange is below where we drill. it drops down there

 

I know I did this write up for a reason.......

Drilling and Tapping for an Edge EGT

 

This is where I put my sensor...

 

Drew, your tip for he 11/32 worked out great. Got it in with no problems nice and easy. Now to wait for the genos stuff to arrive