Stacks?...
#11
RE: Stacks?...
ORIGINAL: DieselDemon
That is a sharp setup. I love stacks. Yours even look good at the bottom.
Cool beans.
[IMG]local://upfiles/12792/AD7D87A9AFAB4072848E3557B9FEA45E.jpg[/IMG]
That is a sharp setup. I love stacks. Yours even look good at the bottom.
Cool beans.
[IMG]local://upfiles/12792/AD7D87A9AFAB4072848E3557B9FEA45E.jpg[/IMG]
Whereabouts in PA are you Racer ??
#14
RE: Stacks?...
ORIGINAL: DieselDemon
Anyway, if you look under your truck Mayfair, you will see that from where the down pipe starts the bottom bend, it is only partially under the firewall. Then you have the length of a regular, extended, quad, or Mega cab, to do some work with the system before you get to the bed of the truck.
And before you ask, I have seen some guys that ......
1. Go straight back with a single pipe and cross over just in front of, or behind the transfer case/transmission center support. It's custom bending no doubt.
Anyway, if you look under your truck Mayfair, you will see that from where the down pipe starts the bottom bend, it is only partially under the firewall. Then you have the length of a regular, extended, quad, or Mega cab, to do some work with the system before you get to the bed of the truck.
And before you ask, I have seen some guys that ......
1. Go straight back with a single pipe and cross over just in front of, or behind the transfer case/transmission center support. It's custom bending no doubt.
[IMG]local://upfiles/42139/5FFCEDD5BE614B679D8ACB697382255C.jpg[/IMG]
#15
RE: Stacks?...
Check this out Mayfair, it shows everything involved...http://www.blackclouddiesel.com/Stacks/stacks.htm#2stak