Holy crap!

I decided to try 16 oz of PS and 16 oz of marine 2 stroke oil. I used Pennzoil synthetic blend ashless mix.

This thing has never been this quiet or smooth. I've always had a slight, high frequency vibration between 1600 - 1800 RPM's and it was non-existant after about 2 miles with that mix.

No idea about the mileage yet, I've only gone about 12 miles on this fill, so we'll see.

On edit: I did stomp on it to pass some turd doing about 15 under the speed limit. Noticed no smoke at all. Was actually surprised as I usually get at least a little burp out of 'er.

 

I have toget some 2 stroke, need some for the pontoon boat anyway and switch to using this brew

 

I got a gallon of the wally world stuff at home that Ive had my eyes on for a little bit. its origional purpose is for my chain saw. . .got some timber to clear out of the back yard

now if I could get my hands on a dump trailer and a front end loader I'd be set

 

I just bought 2 8oz bottles from wallys @ .99 a piece, (not marine though), I'm waitin for the next fill up, which should be today or tomorrow.

 

Could always hit up the local RSC rental place and use one.

 

Ive thought about that. . .and they have a teramite as well that would be perfect, but every time I think I have an open weekend it rains[:@]

 

I tried 8 oz. 2 stroke in a 1/4 tank that had the brew already in it and didn't notice alot of difference. I put 24 oz. 2 stroke in a full tank with the brew and noticed it's alot quieter at cold start but still rattles a little till warmed up. Haven't noticed a change in mileage yet.

 

I'm gonna try a few different concentrations of and see where I stop noticing a benefit.

Also, I need to change the fuel filter this weekend, so I'll see if it's discoloring that or the fuel to any major degree.

 

I was gonna say....if you were closer to me, I'd just grab one of my 3 front enders here at work.

I think that might be noticed if it was gone too long.

 

it is nice isnt it...