figured i would add both my v10s to the mix up. tow pig 98 ext cab long bed v10 and loving it. toy 97 std cab rockcrawler 22" lift on 44 boggers streched in front 8" heres a pic of the toy havent gotten a pic of the tow pig yet. the v10 has no issues crawling a wall with 44s or my 54s on. i will never own a 5.9 again.





and for anyone who wants them i have 3 sets of 4.10 gears sitting at the house. and a couple of custom build axles that eliminate the cad system in the dodge.

 

Nice toy. How low is it geared? Any performance mods to the engine?

I'd be interested in the 4.10's. PM me what you're looking to get for a set for front/rear please.

 

as promised the other dodge toys, the crawler has 4.10s custom made axle shafts (i can make some for you too) 44x19x16.5 boggers uncut 16" travel sway away coilovers now converting to coilovers in rear so if you have any i need a pair.

stock 5.9 dodge 33 swampers might end up getting lift and the spare v10 at the house.



the tow pig with the trailer and with out.

 

I installed the 4.56 gears in the ram last week and have about 150 break in miles on it so far. I'm hoping to rack up some miles on it tomorrow so I can start towing. It was my first gear set install and I think it went pretty smooth. No whining from the diff at all. I pulled the diff cover after 100 miles and the wear pattern seems to be right... the pinion could possibly be shimmed to be into the housing a TINY bit more to get the wear marks exactly in the center of the ring gear, but I think it's extremely close, so I'm going to leave it like that.

Going from 3.55's to 4.56's was a nice jump. The truck doesn't have to struggle going up hills now .

 

Awesome truck ! I am excited to see that truck because I am building a mud truck with 53" v treads and will be taking the bed off also . No mountains or rocks in Florida just sand and mud or I might have gone the rock crawler route . So your running 4.10' s with your 53's ? You must have a special t-case your running right ? What type of suspension did you do and is it homebuilt?
Now how about some action photos ?

 

no action shots yet its back under the knife, it has an atlas case. and my bed is going back on or at least the sides are. its going to have a full exo cage. and before everything is all said and done it might get rockwells.

 

Damn this V10 to hell!!!!! After everything I've replaced, the truck stalls while going around a turn on Sunday. Try to restart and the starter doesn't want to turn the engine at all. Remove starter and it's a pile of rust. Replace with a new one and all new cables. Starts up, but now no oil pressure!@!!!!@@@@!@!@!!! I'm ready to commit some damn insurance fraud on this damn thing!!!!

 

I got my answer about why my truck runs 2500rpm at 70mph. My trans lost 2nd gear the other day and the mech said I never had over drive. 2000$ for the trans out the door.

 

6boltfreak<---How does the truck act while pulling that trailer, and what does it weigh loaded with those results? Gas mileage as well?

As for the axles, how have you built them, and what are you asking for one? I would assume it is just the passenger side with a single long axle.

 

Ok Iam in how many is that 4 ? LOL but how do i join I didnt see anything to click LOL
heres my Truck Just picked it :-)