i got this picture off cardomain. i was wondering if anyone knew how to do this? How do you put the middle part of the bumper inward?

 

Most likely, it was cut out and redone with fiberglass. Some bumpers are pre-molded that way. Others are custom modified with fiberglass. It looks like it was cut out, recessed, fiberglassed, and then primered and painted.

 

EDIT-i was wasnt even looking at the right thing...i apologize...

 

I agree BadStrat. Like I said, its either a pre-molded kit, or its a custom job.

 

Guys, no kit, or fabrication is necessary - that is a stock bumper that has been rolled.

It is very easy to do, and many have done it. Up close, I don't lke the look as muck, personally, but if I did a side exit I might consider.

All you do is pull the strap at the bottom of the bumper up a bit higher and re-attach it. see the following:

http://www.srtforums.com/forums/show...ghlight=bumper

Also note - once it is rolled - you need to keep it rolled, - you will deform/crease the bumper.

 

Yeah upclose it exposes alot of the rear suspension and looks gaff to me. But from above it doesnt look all that bad. And with dual exit exhaust....[:'(]

 

has anyone seen an srt rear diffuser that turboneonstore.com sells on our cars and any performance benifits?

 

Good ? I would like to know also - that thing looks pimp.

 

I did mine like that. It's really as simple as relocating the mounting strap things.

 

[sm=chattypair.gif][sm=youreright.gif]