Hi,
These two plastic mouldings (See below), along with a jar of loose bolts and screws came back with my car (1969 Dodge Charger Daytona) from the first body shop I had sent it to (It was sanded to the metal and painted but no clear coat added because the owner died and the shop closed.). Finding the right place for the bolts and screws took a while but was feasible mainly by locating those that were new or not were they should have been, but I could never figure out where the mouldings go. There's two of them, likely one for the driver side and the other for the passenger side, each measuring 15 3/4" with a width of 3/4". The groove on the back side is 1/8" wide and about a 1/2" deep. Does anyone have any idea where they go? Any help will be appreciated.

Thanks,
Jacques

 

Window moldings? Not long enough for the front doors, maybe rear quarter windows??