snowboundrmk's 360 build
#1
snowboundrmk's 360 build
I've been working on this for a while its coming along pretty slow due to not having money. Plan is full rebuild with higher compression, cam, roller rockers, plenum fix, long tubes, and I was thinking about carb to tune it but I was advised against that by many so I'm trying to figure out a simple megasquirt setup. The mill is from a 99 Durango with 133k on the clock.
#2
#7
Trending Topics
#8
Maybe this one: http://www.hughesengines.com/Index/p...r&partid=11433. I want good power low to midrange. I'm open for recommendations on cams, maybe even the same cam redneck is using.
#9
So these pistons and head gaskets will give me almost 10:1 what do you think?:
Pistons: http://www.summitracing.com/parts/ue...iew/make/dodge
Head gasket: http://www.summitracing.com/parts/dc...ge?prefilter=1
Pistons: http://www.summitracing.com/parts/ue...iew/make/dodge
Head gasket: http://www.summitracing.com/parts/dc...ge?prefilter=1
Last edited by snowboundrmk; 08-14-2013 at 03:31 PM.
#10
I ended up getting stock pistons so the compression will only be a tad higher from the .020 bore. What do you think of this cam? http://www.hughesengines.com/Index/p...2&partid=28053