5.2 magnum turns won't start.
#41
The fuel synchronization was a guess, but if you did not set it right when you built the motor it could help cause the code 51.
Assuming all things are still as they were when you started this thread.
Here is a link to a code interpreter. http://www.dakota-truck.net/CODES/codes.html
The codes you reported 45, 37, 32, 27, 51
Did you fix or resolve the trans codes 45 and 37? 32 EGR code even if the EGR is not working won't affect it much. Ralph's advice is good.
I'm looking at the 51 code as the problem now. This describes it and offers the O2 sensor as one possible source http://www.allpar.com/fix/codes/faults/code-51-52.html
Also the description of code 51 on this page indicates low fuel pressure may cause it. I don't recall whether or not you resolved the fuel pressure issue. http://www.dodgeram.info/Engine-Gas/...fault_code.htm
Based on this I would check the O2 sensor to see what it looks like and make sure the fuel pump is delivering consistent pressure at the right PSI.
Assuming all things are still as they were when you started this thread.
Here is a link to a code interpreter. http://www.dakota-truck.net/CODES/codes.html
The codes you reported 45, 37, 32, 27, 51
Did you fix or resolve the trans codes 45 and 37? 32 EGR code even if the EGR is not working won't affect it much. Ralph's advice is good.
I'm looking at the 51 code as the problem now. This describes it and offers the O2 sensor as one possible source http://www.allpar.com/fix/codes/faults/code-51-52.html
Also the description of code 51 on this page indicates low fuel pressure may cause it. I don't recall whether or not you resolved the fuel pressure issue. http://www.dodgeram.info/Engine-Gas/...fault_code.htm
Based on this I would check the O2 sensor to see what it looks like and make sure the fuel pump is delivering consistent pressure at the right PSI.
I have not gotten the 51 since i changed the distributer pick up and rotor.
When I do the key dance I am getting code "27" 3 times.
#42