1 piece are real PITAs indeed to install. SUX!

IndyD

 

LOL! You got that right, shrp!

 

Yes they are a PITA to get on. The two-pieces can be taken off with a torx drive for the corner lights and a 10mm(?) socket to get the three bolts that hold each one in place. The bolts are not that easy to get to in the first place especially the upper inside ones, I needed the six inch and three inch extensions for my ratchet set. Then there's that flex-type push-in connector for the upper outside hole. You have to be careful with that one cause if you use too much force, you broke a headlight housing. I used a flathead to wiggle them loose. I don't know how anyone will be able to install a one-piece w/o damn near taking off the bumber to access the bolts behind the one-piece. Has anyone done a write-up? I would love to see how it's done.

 

The bumper is only 4 bolts and is EASY to remove, at least on mine?

 

IDK about my bumper. Probably the same 4 bolts. Don't you use them to adjust the bumper height as well? Anyone done the one-piece headlights???

 

They have other adjustment slot holes in them to do a little adjusting.