2002 Durango - overfueling/MAP reading
#11
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
MAP checks out - at least I think it does [see above]. IAC could be it, as I've heard it cycling with the key-on. But opening the flapper or a vacuum line should mostly fix that. Intake charge, I assume you mean the Intake Air Temp sensor. Also checks out with the correct voltage as per the manual.
Have to see this evening.
Have to see this evening.
#13
#14
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
Take #1 plug out and insert a screw driver down to the piston. bring the engine up to just before TDC without going over TDC on compression stroke. Then place the spark plug to ground on the base and slowly manually turn the crank very slowly tell it sparks. Look down on the crank and see how far it is from TDC (retarded or advanced timing) and post the results. With the screw driver in the piston is used to verify the piston position in relation. Post as well.
#15
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
So, turns out that it pays to check things more than once during a problem hunt. [Namely, compression] Turns out that the passenger side cam gear managed to get installed without the dowel located in the recess, so the entire pass side valve events were behind by 30 degrees by the time I recognized the problem. Pull covers, camshaft, and have the old dowel machined out [was pressed into shaft to almost flat when the gear was torqued], put in a new one [15/64" diameter, by the way], put camshaft back in, and a little oil in a couple cylinders to get compression [was washed off cylinder walls by ether]. Put the fuel rail back on, spark plugs and towers on. Hit the key and it fires right up. I haven't felt elation like that in such a long time....
Now of course, the #3 injector has taken a crap, but thats relatively easy after a complete teardown and re-build.
Thought I'd let folks know the end result. We are getting REALLY good oil pressure now, no valvetrain noise. Pays to use a little compressed air to blow out those passages while the engine is apart....
Now of course, the #3 injector has taken a crap, but thats relatively easy after a complete teardown and re-build.
Thought I'd let folks know the end result. We are getting REALLY good oil pressure now, no valvetrain noise. Pays to use a little compressed air to blow out those passages while the engine is apart....