When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Well did the oil change and put the Mobil 1 in it, gassed up and it threw a CEL. This time the code was p1757 the Governor Pressure, checked the fluid and it was low, and added a quart? Anything else I should look for?
Well did the oil change and put the Mobil 1 in it, gassed up and it threw a CEL. This time the code was p1757 the Governor Pressure, checked the fluid and it was low, and added a quart? Anything else I should look for?
A couple of months ago i was also throwing a P1757 code.... after driving it for a few miles it would go away, then a day or so later return..
Finally i decided that i was gonna clean the TB and the IAC, replace the cap, rotor and the plugs and wires. i reset the PCM and the light went out and never came back.
Don't know if it helped the code but, thought id mention it......
Well did the oil change and put the Mobil 1 in it, gassed up and it threw a CEL. This time the code was p1757 the Governor Pressure, checked the fluid and it was low, and added a quart? Anything else I should look for?
For what it's worth, Mopar uses the term MIL (Malfunction Indicator Lamp) and not CEL.
If it stays lit, replace the sensor because it's not a difficult sensor to replace and the MIL will more than likely go away.