Tube Bumper Build
12-01-2013, 09:06 PM
Registered User
Thread Starter
Join Date: Jun 2010
Location: Valley of the Sun
Posts: 21
Likes: 0
Tube Bumper Build
12-01-2013, 10:00 PM
Join Date: Nov 2012
Posts: 414
Likes: 0
Received 0 Likes
on
0 Posts
You're over on "the other forum" aren't you?
12-01-2013, 10:29 PM
Registered User
Thread Starter
Join Date: Jun 2010
Location: Valley of the Sun
Posts: 21
Likes: 0
Yeah I've been a member over here since 2010 just haven't posted much.
12-01-2013, 10:48 PM
Join Date: Nov 2012
Posts: 414
Likes: 0
Received 0 Likes
on
0 Posts
Yeah I thought I had seen this somewhere before. It looks good. I would get one if I had money.
12-02-2013, 05:04 AM
Join Date: May 2013
Posts: 180
Likes: 0
Looks good and sturdy. Can't wait to see the setup for the rear.
12-03-2013, 02:54 AM
Join Date: Sep 2012
Posts: 233
Likes: 0
Received 0 Likes
on
0 Posts
12-03-2013, 07:51 AM
Registered User
Thread Starter
Join Date: Jun 2010
Location: Valley of the Sun
Posts: 21
Likes: 0
The plan for the rear is to tie in the receiver and raise everything a few inches. Then make a swing out tire mount .
12-04-2013, 11:33 AM
Join Date: Nov 2011
Location: Ontario, Canada
Posts: 1,013
Likes: 0
Looks pretty good, did you fabricate it yourself? Is it DOM tubing? It's a nice clean build.
12-08-2013, 11:40 AM
Registered User
Thread Starter
Join Date: Jun 2010
Location: Valley of the Sun
Posts: 21
Likes: 0
12-08-2013, 12:31 PM
Join Date: Dec 2010
Location: Ontario, Canada
Posts: 1,075
Likes: 0
Nice job that looks real good.
Is that bedliner on the last pic?