Truck starts and drive BUT P0136 w/ new o2 sensor
#1
Truck starts and drive BUT P0136 w/ new o2 sensor
Hello, I bought a 2002 Dodge Dakota 4.7 Auto 2wd with 205k about 6 months ago had it when it had multiple random misfires.
Changed the PCM out with a brand new one. PCM works because I put it in another guys truck and it worked in his 4.7. He drove it floored it it works
changed the camshaft position sensor (Now it wont start)
changed throttle position sensor
changed Idler Air Control Valve
All O2 sensors
Spark plugs seem to be change out because when I bought the truck it had the spark plugs in the truck bed
changed out the coil pack
Battery is new
Alternator works
Starter works
Wires are good
Changed out the ABS sensor
A facebook friend of mine said the woodruff key is knocked out and he said while I'm at it I should change out the timing chain. I asked a local Dodge lover if that was the case he said no because I would hear it and feel it if that was needed.
Where is the Crankshaft position sensor located I want to change that too. I think that is the part I need to get the car to start up. I put the old Camshaft position sensor and it starts up (but with multiple misfires.)
What does the Crankshaft position sensor look like and where is the part location on the truck?
(running and driving with Mutiple misfires old camshaft position sensor)
Changed the PCM out with a brand new one. PCM works because I put it in another guys truck and it worked in his 4.7. He drove it floored it it works
changed the camshaft position sensor (Now it wont start)
changed throttle position sensor
changed Idler Air Control Valve
All O2 sensors
Spark plugs seem to be change out because when I bought the truck it had the spark plugs in the truck bed
changed out the coil pack
Battery is new
Alternator works
Starter works
Wires are good
Changed out the ABS sensor
A facebook friend of mine said the woodruff key is knocked out and he said while I'm at it I should change out the timing chain. I asked a local Dodge lover if that was the case he said no because I would hear it and feel it if that was needed.
Where is the Crankshaft position sensor located I want to change that too. I think that is the part I need to get the car to start up. I put the old Camshaft position sensor and it starts up (but with multiple misfires.)
What does the Crankshaft position sensor look like and where is the part location on the truck?
(running and driving with Mutiple misfires old camshaft position sensor)
#2
Check for codes. You don't need a reader.
With the key OFF, turn it to RUN (not start), back to OFF, then to RUN, back to OFF, and this time leave it in RUN.
Any codes will appear in the odometer window.
The CKP is on the right side of the engine at the rear. It fits into a hole and can be very difficult to remove.
With the key OFF, turn it to RUN (not start), back to OFF, then to RUN, back to OFF, and this time leave it in RUN.
Any codes will appear in the odometer window.
The CKP is on the right side of the engine at the rear. It fits into a hole and can be very difficult to remove.
#7
Trending Topics
#8
#10
This picture cracked me up. That is just oh-so-familiar....... If I want to work in the garage, I either have to leave the girls in the house, or close up the garage.... (and then the whine and scratch at the doors......)