Where did my Project Thread go????
#11
#13
Well... I took another look at teh line and right at the disconnect i use my "special tool" (wrench) and was able to get it disconnected.. I hope it will go back together.
I was able to feed the line so far to manuver the master cylinder to a spot where I can use a bit small enough to use as a punch.
I knocked out the pin and the hard line poped off.
Here is that P.I.T.A. pin..
Here is the cylinder removed.....
It was a bit easier putting it back in and reassmebled in the car... I haven't filled the resivor up yet. I need to figure how I bleed the system ...
I was able to feed the line so far to manuver the master cylinder to a spot where I can use a bit small enough to use as a punch.
I knocked out the pin and the hard line poped off.
Here is that P.I.T.A. pin..
Here is the cylinder removed.....
It was a bit easier putting it back in and reassmebled in the car... I haven't filled the resivor up yet. I need to figure how I bleed the system ...
#14
Well I've been out of town so I haven't worked on the clutch system in awhile... I put fluid in the system today, but need an extra hand with bleeding it...
On a second note, I received a call from a friend about some parts... I picked them up yesterday from the junk yard on my lunch.
What do you think?????
I got them for a great deal... 350.00 for all.. so what do you think????
Here is today pics...
and a pics of my license plate cover from being Car of the Month of March
Oh I also installed the booger bushings... so no more shift play...
On a second note, I received a call from a friend about some parts... I picked them up yesterday from the junk yard on my lunch.
What do you think?????
I got them for a great deal... 350.00 for all.. so what do you think????
Here is today pics...
and a pics of my license plate cover from being Car of the Month of March
Oh I also installed the booger bushings... so no more shift play...