Pulled some old wire fencing out of the ground, it was completely wrapped up in a huge thorn bush...

 

Finally got around to putting my dash bezel back in came out a little lighter then i would have liked but such is when your working with pre-mixed paints

 

Cut the runners and shortened the divider in my plenum before I swap engines. I'll pick up some carbide bits tonight, so I can smooth out the edges. I'll also use them to gasket match and bowl blend my heads while Im installing new valve seals and lapping my valves.
Also, I noticed in other peoples threads about the plenum mods, they eliminate the center divider. Mine has an EGR port, and a tube cast into the divider, so I just shaved off the material on top of that. Anyone else seen this?

 

I remember someone saying they cut the EGR tube flush with the wall of the manifold on the inside and didn't have any problem.

 

Looks good!

 

Hmmmm..... Now the gears are turning. That sounds simple enough, if it works. Also, on my EFI swap thread, HeyYou mentioned EGR delete... Decisions, decisions...

 

Drove my Cummins today. Was out of town all week again. So hot rdding around in the rain was fun


Monday I leave for 15 days

 

Where ya goin'?

 

Eastern WA again. We were only running 10 hour shifts this last week, which was stupid. If I am out of town I want to be worked like a mule and get paid. Instead we sat around the hotel. The week before I got 71 1/2 hours, but last week only 49. Frustrating.

 

Beter than 20.