Repaired rear drivers door latch cable with custom cable holders nothing to special but I am looking forward to doing the plenum on my truck soon (not really would rather be fishing) cause its got issues.

 

Oh good to know. I was thinking about buying one but I guess not. Where did you end up getting it done at? how much did it cost?

 

well i bought/ordered some new parts today...180 deg t-stat, new sirpintine belt (damn they are more expencive than i rember or i got hosed gonna check another place tomorow), new autolite plugs, msd wires napa brass cap and roter. now i just need time to put it all in, hopfully this week and then next week itll be 4.10 gears

hey what do you guys think, should i do the coil while im at it? if so whats a good brand?

 

Drive just over 550+ miles. Gonna do it again Thursday and keep track of mpg this time.

 

added my cb radio and installed antenna

 

I got it done local at Swain and Sons
They did an outstanding job, and I'm real particular about how anyone dose anything on any of my rides (which is rare). They did it for right for a little over $300 with a warranty and a Forza-Flow muffler. Sounds nice.

 

I limped my over to the repair shop to have the tranny rebuilt. I am missing it my truck already. Is there a support group for this.

 

I used a 3 axle heavy equipment trailer to haul home a pair of 83 nissan pickups. Sure was a dog on the highway but she got the job done. Oh and one of the nissans was said to have a cracked block but i got it fired up and its just a leaky heater hose. The other one just needs a clutch. Not bad for freebies.

 

made a homemade air intake and added a 180 degree thermo

 

Installed 4 brand new KYB MonoMax shocks on me dodge, gonna install the new dash cover, from Coverlay tommorrow. Whoo Hoo