What Did You Do To Your 2ND GEN RAM Today?
Went out and played with my four wheel drive today.... turns out, the problem was a poor connection at the cad. The little boot that goes over the vacuum ports on the actuator are getting kinda loose. Temp fixed it with zip ties for now. That new harness and such is lookin' pretty tasty..... either that, or the posi-lok...... new harness is certainly cheaper......
Same as these ones:

Factory heated leather seats.
Only a cubby hole on trucks that didn't come with the option.
Whenever there is a cubby hole somewhere on a dash...it's not for your convenience. It's to take place of optional equipment that wasn't installed. Cheaper to make the same dash for all of them and put a blank piece in than to make two separate dash designs to accommodate optional equipment.

Factory heated leather seats.
Only a cubby hole on trucks that didn't come with the option.
Whenever there is a cubby hole somewhere on a dash...it's not for your convenience. It's to take place of optional equipment that wasn't installed. Cheaper to make the same dash for all of them and put a blank piece in than to make two separate dash designs to accommodate optional equipment.
That's pretty coolio. Do your still work?
Crankcase was overfull. With what or why I do not know yet. Gonna look at it today. I suspect the floats in the carb went haywire, maybe they froze. After all I was driving through a 64 degree temperature drop.
Whatever it was, it happened fast.
Whatever it was, it happened fast.
Or was it that you blew them off on an up hill run?










