When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
well i also started to eyeball a second trans cooler... also gonna be putting an ext filter, as well as trans temp gauge in...any ideas on where the best/most accurate place would be to put the sending unit?
drove 250 miles home, the cat delete threw another CEL, shut the truck down, refired it, no cel for the last 70 or so miles, i think i need to reset the computer
drove 250 miles home, the cat delete threw another CEL, shut the truck down, refired it, no cel for the last 70 or so miles, i think i need to reset the computer
well i also started to eyeball a second trans cooler... also gonna be putting an ext filter, as well as trans temp gauge in...any ideas on where the best/most accurate place would be to put the sending unit?
miami put his on the back side of the pan i believe, to block from wind and so the fluid is pushed back there
Plugs in cylinders 1 & 8 had a very small amount of oil, just enough to make the threads wet. Not sure if this is indicative of anything?
see if the low side of the valve cover has any oil around the gasket. my plugs used to get a good little bit of oil on them from a bad valve cover gasket leak. it did make the plug heat shields easy to pull out though.