What Did You Do To Your 2ND GEN RAM Today?
#4432
Brought my truck to a shop for the first time since ive owned it...I always do my own work...but just dont have the time to work on it myself due to work...just starting to get her ready for moose hunt next month...
this is what im getting done...
-Grease Front End
-Check u-joints on driveshaft (looks like i broke a clip)
-Trans Flush/Filter change
-Transfer Case flush
luckily my old boss is doing it for me...i pay for fluids and $20 for labor
this is what im getting done...
-Grease Front End
-Check u-joints on driveshaft (looks like i broke a clip)
-Trans Flush/Filter change
-Transfer Case flush
luckily my old boss is doing it for me...i pay for fluids and $20 for labor
#4433
#4435
#4436
got the truck back today...
-Tranny fluid is mint
-Transfer Case fluid is mint
-Front ends all greased
-fixed my brake problem, (rear hardware was froze up on pass. side)
-U Joints are fine
-Coolant topped off
-found no problems with front end parts
-Found a slight coolant leak though....timing cover gasket...again
-checked front and rear diff fluid, and alls good
he went over pretty much the whole truck, and my old boss said the truck is in real good running shape....then he gave me crap about my rockers and doors, because he has a set of doors from a ram he just parted out
-Tranny fluid is mint
-Transfer Case fluid is mint
-Front ends all greased
-fixed my brake problem, (rear hardware was froze up on pass. side)
-U Joints are fine
-Coolant topped off
-found no problems with front end parts
-Found a slight coolant leak though....timing cover gasket...again
-checked front and rear diff fluid, and alls good
he went over pretty much the whole truck, and my old boss said the truck is in real good running shape....then he gave me crap about my rockers and doors, because he has a set of doors from a ram he just parted out
#4438