The Official 2nd Gen RAM Forum OT thread
#8521
Mine used to leak like a black lab in heat but after every gasket and seal being replaced at least once it does alright, still need to redo the intake gasket though, it leaks out the back.
#8523
Not truck related, but definitely one of those "I'm an idiot" moments.
Had a Dell laptop with a bad motherboard. Ordered a new one under warranty. When I was troubleshooting it before I knew it was the motherboard for sure, I had it sitting on my desk to the right side. After diagnosing bad motherboard, had my co-worker order the part. Moved it to the cabinet behind me while we waited the day or two for the part.
Got it in one morning, and grabbed the laptop immediately to my right. Started tearing it apart. Replaced the motherboard, and was all the way back to the final stages of reattaching the keyboard before I realized... the laptop with the bad motherboard was behind me on the cabinet, not this one.
Needless to say, after taking it back apart and fixing my screw-up, and then actually fixing the bad laptop from the cabinet behind me, I am now an expert with taking apart the newer Dell laptops.
Had a Dell laptop with a bad motherboard. Ordered a new one under warranty. When I was troubleshooting it before I knew it was the motherboard for sure, I had it sitting on my desk to the right side. After diagnosing bad motherboard, had my co-worker order the part. Moved it to the cabinet behind me while we waited the day or two for the part.
Got it in one morning, and grabbed the laptop immediately to my right. Started tearing it apart. Replaced the motherboard, and was all the way back to the final stages of reattaching the keyboard before I realized... the laptop with the bad motherboard was behind me on the cabinet, not this one.
Needless to say, after taking it back apart and fixing my screw-up, and then actually fixing the bad laptop from the cabinet behind me, I am now an expert with taking apart the newer Dell laptops.
#8526
notice how that chebby has a solid front axle with crossover steering instead of that factory junk independent front suspension with drum sticks for tie rods?! HUGE strength improvement!
It still looks awful though...
#8528
#8529
Got a new (new to us) push mower today. Has the good ol' Craftsman 21/22" 3-in-one deck and then to top it all off a awesome Briggs 6HP industrial engine! Runs awesome...
Also looked at a really nice rider, might end up getting it too.
Also looked at a really nice rider, might end up getting it too.