guys! question? i have a 96 4x4 with the 1 ton steering system. WHERE CAN I FIND REPLACEMENT TIE ROD BOOTS?
man! have i looked everywhere for those "puck style" boots?

 

Don't think you can get just the boots...... could try energy suspension, or other manufacturers that do poly bushings and such for assorted vehicles..... might get lucky.

 

Sorry bud that should have read as @Info, send me a email so to make sure I have the right address for you.

You should be safe in NB out here I am starting to run into issues, anything lifted more than 10cm must go through a VI which is fine. I just need to install fender flares and a new windshield and possibily and new front bumper that hangs lower to the ground.

Edit; Sorry I have not sent you an email yet, I am busy getting the camp ready for this year's flooding which is about two months early #$#@*!

 

10 cm? is like just under 4 inches. Did you mean that?

ahhh crap....flood time. Sorry dude and be safe!

 

^^^^ Yep 10cm is it then VI.

Maximum suspension height 10cm truck is then subject to a VI
Maximum head lamp height 137cm to the middle of the lens
Maximum tail lamp height 183 cm
Maximum front bumper height 750mm to the bottom of the bumper
Splash & spray devices YES

Just one year without a flood would be nice. If it goes as per usual it will last three weeks then subside, it's too early this year. I just hope its not as bad as last years.

 

Last year was friggin' horrid.... some of the pics/videos you posted were insane.

Good Luck man.

 

Off topic sorry Info

^^^ I will post pix when it happens, it should break the river bank late this week.
Thank you guys for the good luck.

 

no good! tried there and a couple of other urethane boot guys. this 99 1ton system just seems to slip through the cracks when it comes to aftermarket support. a general boot is available but, the puck style isnt !
by the way, what was this thread about?

 

I might like to see those.....

 

the dodgeoffroad version will be available in about 1-2 weeks.
here's the story.
price will be about $600 or less.

also a lot of discussion about the different options, the 2 sizes of taper, etc.

http://www.dodgeoffroad.com/viewtopic.php?f=4&t=1422