When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Well hell, me 3. Should be here in a day or two. opted for black. The real kick in a$$, I ordered an AEM dryflow to go with it, and it was backordered. Won't see it for about 3 weeks, but cruised by my local AAP and they have it sittin on the shelf.
Can someone post a photo of how you attached the small intake filter on the valve cover?
I don't have a picture, but I'll tell you this.
I pulled the PCV out. I then noticed that the plastic elbow can be removed from the rubber grommet that sealed it into the valve cover.
I separated the two and put the grommet back into the the valve cover.
Then through a trial and error, I found that if I removed the metal hose clamp from the breather filter. I then wrapped the rubber neck of the breather with black electrical tape until it provided a snug fit and good seal inside the rubber grommet. (Kind of bubba rigged, but it works!)