DodgeForum.com

2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Best wheel/hub bearing?

Thread Tools
 
Search this Thread
 
Old Nov 19, 2009 | 02:35 AM
Share
  #21  
Sheriff420's Avatar
Sheriff420
Grand Champion
Joined: Apr 2008
Posts: 7,055
Likes: 7
From: Lee County, North Carolina
Default
max, you should go with Timken, i've always heard that they are the best.
aren't your axle seals still leaking? if they are then you should get those replaced when you replace the hubs.
 
Reply
0
Old Nov 19, 2009 | 10:12 AM
Share
  #22  
dodge15004x45.9's Avatar
dodge15004x45.9
Legend
Joined: Nov 2008
Posts: 7,950
Likes: 2
From: Malvern Pa - Canadensis Pa
Default
No for some reason they stopped leaking.
 
Reply
0
Old Nov 19, 2009 | 10:23 AM
Share
  #23  
Sheriff420's Avatar
Sheriff420
Grand Champion
Joined: Apr 2008
Posts: 7,055
Likes: 7
From: Lee County, North Carolina
Default
thats probably because the front diff is so low on fluid that it isn't getting slung against the seal any more. which is bad.
 
Reply
0
Old Nov 19, 2009 | 07:47 PM
Share
  #24  
dodge15004x45.9's Avatar
dodge15004x45.9
Legend
Joined: Nov 2008
Posts: 7,950
Likes: 2
From: Malvern Pa - Canadensis Pa
Default
No there is fluid in there. It hasent leaked in a while. I hope I would have noticed it leaking like I did last time. When the end of my axle where soaked.
 
Reply
0
Back to Subforum
2nd Gen Ram Tech
View Next Unread
97 5.9 won't start




Advanced Search
Reply Closed Thread Share
Forum Jump

All times are GMT -4. The time now is 01:47 AM.