D60 Specs
#11
VEETEN is correct. The axle nut is torqued to 175 ft.lbs. for pre 2000's, and 180 for 2000 up. Its the bolts that secure the bearing to the knuckle that are only 122-125 ft.lbs.
And the torque IS critical, as too much or not enough will cause pre-mature failure. I recommend torquing it down, and if the cotter pin wont go through, then break off the tab's in the way.
And the torque IS critical, as too much or not enough will cause pre-mature failure. I recommend torquing it down, and if the cotter pin wont go through, then break off the tab's in the way.
#12
#13
I've been joking since I joined this forum that I got the limited edition special truck.....LOL.
rock auto had them for like $320 I don't wanna know what the dealer want's for them.....
#14
lol... well, i can see why with the bolts and everything, bt you need to look into an online store... you can find them for like 260, 280... and they come right to your door.. lol, but anyway.. is that what yoru hubs are tighten to there veeten? 180? seeing as how it seems youve replaced t least one...