Damn that sounds good.

 

There will be no updates today because its f'ing raining

 

Got everything wired up today. Fired it up let it run. Fans worked great. Noticed a leak where my tranny temp sensor is. Tried to tighten it up. I think I got the one leak. Where the sensor itself is has a leak. Also noticed where the line goes into the Rad is leaking. I thought it wasn't bad enough to hurt so I took a few laps in the parking lot. When I parked it the fluid was running out pretty good. I gotta work on that tomorrow. Also need to call summit about a coil.

Will post a couple vids in a bit

 

just a few questions for you if you dont mind.

Where did you order the heads from?


What do you think the total cost of the build was, with the heads and getting motor bored out and all?

And what rebuild kit did you use? Did you piece it together or find a good one?

Im doing the same thing soon, ive been to busy with work to start the project but im going to get new heads and rebuild kit or the 408 stroker.

 

^thats what he used for heads....


i wanna hear it lol

 

http://www.youtube.com/watch?v=rPWCyls4AV0


Sounds so much better in person

 

thats sounds awesome....almost like a cummins lol

does it have a vac. leak?

 

When are we racing?

 

Not sure. It might just be sucking that much air now.

Not for a while. Gotta break it in first.

 

Yea better to wait for the spring. We can get greg to film it. lol.