getting a wrecked 2500
#1
getting a wrecked 2500
I am getting a 2500 with the v10 that has been rolled. Everything but the body is good. Has less than 100k on it and is a 97 i think. So i dont have much time to search on here but what can i use off it? I am thinking the dana 60s the t-case and the tranny? I want easy bolt in(no extreme fab work) I am pretty sure the axles are easy right? What about the tcase and tranny? It has the v-10 and a 5 or 6in lift on it and 35s axles have 456s and Detroit lockers. Its a short box club cab like my truck. It is a sport too. So it short i want to put the 3/4 ton axles in my truck and if its easy enough the tcase and tranny. What about the engine?
Josh
Josh
#2
i'd go for it...those axles would be a killer upgrade...and IIRC...the V10/cummins trucks had a dana 70 rear and 60 front....
the trans won't bolt up b/c the cummins/V10 trans had a different bellhousing pattern....but the case probably would if the input shaft is the same size/spline count (and that case would make it much easier to put the axles in b/c of the tcase end of the driveshafts)
now, the motor, i really don't know, it could be done, it would be much easier though if the trucks were the same year...
the trans won't bolt up b/c the cummins/V10 trans had a different bellhousing pattern....but the case probably would if the input shaft is the same size/spline count (and that case would make it much easier to put the axles in b/c of the tcase end of the driveshafts)
now, the motor, i really don't know, it could be done, it would be much easier though if the trucks were the same year...
#6
#7
Trending Topics
#8