2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

wont crank help

Thread Tools
 
Search this Thread
 
Old Dec 19, 2010 | 05:33 PM
  #1  
ostrx250's Avatar
ostrx250
Thread Starter
|
Registered User
Joined: Oct 2010
Posts: 14
Likes: 0
Default wont crank help

neighbor has a 97 2500 good battery smoked cab ground on left side melted a vac line has good battery but start relay just busses anyone have a trouble shooting guide
 
Reply
Old Dec 19, 2010 | 05:54 PM
  #2  
HeyYou's Avatar
HeyYou
Administrator
Veteran: Air Force
Community Favorite
15 Year Member
Community Builder
Joined: Apr 2010
Posts: 87,366
Likes: 4,209
From: Clayton MI
Default

did you fix that ground?
 
Reply
Old Dec 19, 2010 | 06:45 PM
  #3  
ostrx250's Avatar
ostrx250
Thread Starter
|
Registered User
Joined: Oct 2010
Posts: 14
Likes: 0
Default

yes no change relay just busses like its bad switxh it with another no change
 
Reply
Old Dec 19, 2010 | 06:51 PM
  #4  
HeyYou's Avatar
HeyYou
Administrator
Veteran: Air Force
Community Favorite
15 Year Member
Community Builder
Joined: Apr 2010
Posts: 87,366
Likes: 4,209
From: Clayton MI
Default

Swap the starter relay with another one, give it a shot.
 
Reply
Old Dec 24, 2010 | 01:25 PM
  #5  
ostrx250's Avatar
ostrx250
Thread Starter
|
Registered User
Joined: Oct 2010
Posts: 14
Likes: 0
Default

already did no changed think i found the problem solinoid wire and pos cable at starter were arcing plastic is melted does anyone know of any fusable links i wish he had a shop manual or something to refer to he took it to a gas station they havent touched it in 2 days no they are not busy
 
Reply
Old Dec 24, 2010 | 01:58 PM
  #6  
HeyYou's Avatar
HeyYou
Administrator
Veteran: Air Force
Community Favorite
15 Year Member
Community Builder
Joined: Apr 2010
Posts: 87,366
Likes: 4,209
From: Clayton MI
Default

There may be a fuse in the PDC. (power distribution center, up on the drivers side fender well, right behind the battery.)

There is a 2001 factory service manual available for download in the faq section here. wiring diagram for starter should be accurate for you.
 
Reply
Old Dec 26, 2010 | 10:57 AM
  #7  
ostrx250's Avatar
ostrx250
Thread Starter
|
Registered User
Joined: Oct 2010
Posts: 14
Likes: 0
Default

yea i was hoping for a schematic to the relay i believe the wire was backfeeding the ignition no fuses blown pds box i didnt see any fusable links darn kids at work everytime i have a chance to look at it i havent been able to check voltage during start cycle other then battery, got a friend says he may be able to access alldata for the info
 
Reply




All times are GMT -4. The time now is 06:49 AM.