When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Need to test the injector harness. make sure the pcm is actually firing them. they should have 12 volts on one wire for about 3 seconds after you turn the key on, or crank the engine.
I cant find the location of the injector harness in the FSM any tips? also how do you test these wires with a volt meter? are there any bare metal spots?
injector harness runs to the injectors, that's where ya test. just unplug them, one at a time, (don't lose the little metal clips that lock them inplace.....) One wire will have 12 volts.... (with the aforementioned conditions....) check that hey actually have power first. (I think the power feed is common, so, if one has power, they all should)
alright tommorow i can take the day off of work to get the ram going. So tommorow im going into autozone to get a noid light to test the injectors. I will also grab a crankshaft position sensor while im there just incase. Im going to have a brand new truck after all is said and done. Its a good thing i had enough money saved up for such an occasion.
Yep I always try to keep a "cushion" for times like this and my girlfriend likes to just blow money and doesn't understand why I keep some on the side.
Definitely check to make sure your getting fire from the plugs. Did you change the fuel filter? See if you can get the tube for the charcoal canister back on. I don't know if it will make it run bad or not at all but its possible right?