2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

abs/brake light on

Old May 23, 2011 | 09:13 PM
  #1  
sportrider's Avatar
sportrider
Thread Starter
|
Registered User
Joined: Dec 2010
Posts: 5
Likes: 0
Unhappy abs/brake light on

Abs/Brake light came on the other day. Looked on the forum on older posts and one said to replace the rear abs/speed sensor on the rear axle. Replaced it today and unfortunatly did not fix the problem. Would hate to take it to the dealer because we all know they tend to break it off in your *** any chance they can. Any help would greatly be appreciated!

I also unhooked the battery to "reset " the computer but to no avail.
 

Last edited by jasonw; May 26, 2011 at 02:11 AM. Reason: Merging double posts.
Reply
Old May 24, 2011 | 08:06 PM
  #2  
HeyYou's Avatar
HeyYou
Administrator
Veteran: Air Force
Community Favorite
15 Year Member
Community Builder
Joined: Apr 2010
Posts: 87,385
Likes: 4,211
From: Clayton MI
Default

What year is your truck, and does your speedometer work? How do the brakes feel?
 
Reply
Old May 25, 2011 | 06:35 PM
  #3  
sportrider's Avatar
sportrider
Thread Starter
|
Registered User
Joined: Dec 2010
Posts: 5
Likes: 0
Default abs light

My truck is a 97 1500 2wd. Brakes are good. No problems stopping!Speedomotor is working fine.
 
Reply
Old May 25, 2011 | 09:13 PM
  #4  
HeyYou's Avatar
HeyYou
Administrator
Veteran: Air Force
Community Favorite
15 Year Member
Community Builder
Joined: Apr 2010
Posts: 87,385
Likes: 4,211
From: Clayton MI
Default

do you have 4 wheel antilock by some chance??? (look under the front, and see if you have wires going to the front hubs.....)

Recheck the connector for the rear sensor.
 
Reply
Old May 26, 2011 | 01:05 AM
  #5  
Murphy 1112's Avatar
Murphy 1112
Rookie
Joined: Apr 2011
Posts: 67
Likes: 0
From: Edmonton, Alberta
Default

I have the exact same issue. Replaced the sensor this past weekend and lights are still on. I went to the dealership today to get the other end of the electrical connector and will try that. That is if I can figure out how to assemble it. For 55.00 they give it to you in pieces. Some assembly required, lol.
 
Reply
Old May 26, 2011 | 04:09 PM
  #6  
sportrider's Avatar
sportrider
Thread Starter
|
Registered User
Joined: Dec 2010
Posts: 5
Likes: 0
Default

My truck has 2 wheel anti-lock brakes. Plan on taking off back drums to look at brakes. I myself replaced all 4 brakes about 4 months ago. Truck seems to stop real good with no obvious issues. Went to AutoZone today ,asked them if they read Abs codes and they said no,they did'nt. Is there any place that does besides the dealer?
 
Reply
Old May 26, 2011 | 04:23 PM
  #7  
HeyYou's Avatar
HeyYou
Administrator
Veteran: Air Force
Community Favorite
15 Year Member
Community Builder
Joined: Apr 2010
Posts: 87,385
Likes: 4,211
From: Clayton MI
Default

Any indie shop that has a good scanner should be able to pull codes. They may or may not charge you for that little service......
 
Reply
Old May 26, 2011 | 08:53 PM
  #8  
JackJ's Avatar
JackJ
Captain
Joined: Nov 2008
Posts: 742
Likes: 0
From: Virginia Beach, VA
Default

Did you check the connector under the hood, mine was on and I could not figger it out for about a week, until I remebered I had to pull it to replace my shocks and it was only half in.

Some times it is the stupid **** that makes stupid problems happen.
 
Reply
Old May 27, 2011 | 04:15 PM
  #9  
sportrider's Avatar
sportrider
Thread Starter
|
Registered User
Joined: Dec 2010
Posts: 5
Likes: 0
Default

Is it right below the brake resevoir?
 
Reply
Old May 27, 2011 | 08:51 PM
  #10  
SilverSS's Avatar
SilverSS
Captain
Joined: May 2011
Posts: 652
Likes: 0
From: Central Florida
Default

I'm having the same problem. My abs light flashes the whole time I'm driving. Truck is a 98 1500 2wd. Replaced the rear abs speed sensor with no difference. I get a little pulsation when I push on the brakes sometimes though. Any help would be great!
 
Reply

Thread Tools
Search this Thread

All times are GMT -4. The time now is 08:52 AM.