When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
I have a Alpine head unit that has am integrated Sirius tuner in it so you just have to run a wire with the little magnetic reciever to the top of the truck right above the light.
Id get something like that
The Pioneer I have is a AVIC-N1, I have the XM module, but I have more than just the truck and I like to move the radio with me. The vehicle mount for the Onyx lets me do that.
Originally Posted by jmhai
Mine is mounted on the air bag controller cover w/remote.. no remote? ouch...Also A 96 with no cracks in dash, mine was made in Mexico..
Yeah, no remote is kinda suck-ish. Do you, or anyone who looks at this thread, think that my gluing it to the dash would work? Like where the red circle is in my pix. It is easily accessible there.
I updated my pictures, I also found a remote on ebay that supposedly will work. I ordered it and will report back. I still want to put it where I have outlined in the second and third picture. Nobody has answered, will hot glue damage the dash? It will be a permanent install.
I don't think it will damage the dash as it is not hot enough to actually melt the plastic. I am also not sure that it will hold permanently. Worst case, you can try it and if it falls off, come up with a plan B.
How about Velcro instead of hot glue, What about some kind of bracket that clips onto the cup holder? 3m body trim tape, its two sided and mega strong.
09-11-2011, 06:48 PM
