You can also check either the DIY or General Discussion for the thread on Build Sheet OR go by your local dealer. They can run it for you (you will need the VIN).

This is good info to have. It will list everything that was put on the vehicle at the factory.

 

Thats a negative on the wires from the front hub. I replaced them about a year ago and there was none. So i take it that means its not the 4 wheel ABS

 

correct. however, you may still have 2 wheel abs

 

Nope, that leaves you with RWAL. Which is pretty much worthless. A couple pounds of extra metal, and a FAT bump in price tag...... for no real gain. I think it was a gimmick dodge used to imply it was 'safer', when in all reality, it ain't.

I was just kinda curious what the solenoids and such in the last pic were, in front of where that connector was.

 

Ok yea I was just curious because that one wire said PTO on it.. Didnt know if it was factory or not

 

I highly doubt.

 

I don't have that wire plug on my truck. Either that of on mine it's hidden and not loose. It's next to the master cylinder, right?
Sorry for the threadjack, I just went out to see if I have one and was intrigued to find that I didn't.

 

Yea it was above the master cylinder and that PTO wire was under the weather stripping pretty much right above my intake

 

Yeah, I don't have that plug. Weird. Must be a 98 thing.
As far as the "PTO" wire. That is likely something the PO did to the truck that hasn't affected anything yet. lol

 

haha yea "yet" being the key word... now ill experience all different kinds of electrical problems lol