What heads?
Just get Mopar 2.02 intake valves and haver a reputable machins shop put em in.
I have (4) 2.02, new in the box, I'll never use em 65 bucks shipped for all 4, you can find the other 4 on Mancini.

 

Hey what lifters are you using? I bought the cheap SMPs and they are noisy, they seem to bleed down after a an hour or two after engine is off, then takes warm up to quiet down.

 

I think ma Mopar has the Mopar performance lifters for around 110 bucks....

 

http://www.ebay.com/itm/401022090430...%3AMEBIDX%3AIT

 

Thank you for the recommend and link my friends.

 

Sorry for not replying, i had surgery on Tue so Ive been laid up. I got what your saying about machining and putting the 2.02 valves in. I dont want to go that route. The heads are brand new and I just had a comp valve job done that cost 250. I dont want to start machining again. If they were used maybe. It would be easier to buy them done already for me.

I used seled power lifters. I dont know how they hold up yet as far as bleed down, I havnt even primed the motor. I did hear ithrough numerous posts that the mopar performance lifters were not that good.

I guess my project is on hold for a bit until my heads sell. I did just receive my throttle body from HIPOTEK though

 

Where they listed? On the forum here?

 

No, I couldnt list them here. I dont think I have enough posts. Im also a member at dodge talk so I listed them there for now. Im probably going to toss them on Ebay as well.