DodgeForum.com

2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

ECT Sensor question

Thread Tools
 
Search this Thread
 
Old May 10, 2018 | 06:32 PM
Share
  #41  
Rinn's Avatar
Rinn
Thread Starter
|
Amateur
Joined: Apr 2018
Posts: 30
Likes: 1
Default
Are you talking about the mark on the pick up coil or is there a mark on the distributor itself
 
Reply
0
Old May 10, 2018 | 07:16 PM
Share
  #42  
2bit's Avatar
2bit
Record Breaker
Joined: Jul 2014
Posts: 1,362
Likes: 35
From: Wisconsin
Default
 
Reply
0
Old May 10, 2018 | 08:13 PM
Share
  #43  
Rinn's Avatar
Rinn
Thread Starter
|
Amateur
Joined: Apr 2018
Posts: 30
Likes: 1
Default
Thanks for the pic. I will try to get it as close as I can tomorrow and see if it runs better
 
Reply
0
Old May 11, 2018 | 06:42 AM
Share
  #44  
Moparite's Avatar
Moparite
Grand Champion
Loved
Community Favorite
10 Year Member
Community Builder
Joined: Feb 2015
Posts: 7,435
Likes: 578
Default
You need to make sure #1 cylinder is at the top dead center ON THE COMPRESSION STROKE then set the dizzy like this...
 
Reply
0
Old May 16, 2018 | 07:55 PM
Share
  #45  
Rinn's Avatar
Rinn
Thread Starter
|
Amateur
Joined: Apr 2018
Posts: 30
Likes: 1
Default
Thanks for the pics and the suggestion to drill and tap the plenum for the second engine coolant sensor 2Bit. Only took a little over an hour to it. Truck is running better. Im going to take it to the dealer to have the pcm flashed and the fuel sync set correctly. I will have them diagnose it if that doesnt solve the problem. I cant thank everyone enough for all the info and advise you guys have given me.
 
Reply
0
Back to Subforum
2nd Gen Ram Tech
View Next Unread
Torque Converter Failing?




Advanced Search
Reply Closed Thread Share
Forum Jump

All times are GMT -4. The time now is 06:18 PM.