So my head unit went out, I bought a new head unit and hooked it up. No sound. The amp on the back of the unit hooks up, but no sound. Are my speakers blown? How do I reset the wiring in case that is the issue?

 

What was in there originally? What did you replace it with?

 

it was a pioneer, and i replaced with a jvc

 

Recheck your wiring. Does the amp need a separate power feed? Or a trigger wire from the head unit?

 

not sure.

 

Need ta figger that stuff out.

 

Does the wiring use the proper adapter. I always dread going in when someone just cuts wires. It leads to issues like this down the road. When I replace the factory unit with an aftermarket one, It's plug and play when you use a simple kit.

The Mopar radio wiring from the mid 1980's to 2001 was pretty simple. Keep in mind the signal to the speakers has a positive to and a negative from th speaker. Older radios grounded to the chassis but that changed around 1980 or so.