for those of you who have replaced the trac bar. I havent had a chance to get under and check it out yet. Is it pretty easy to do? Does it just bolt right up? Any special tools needed?

 

Here's one for the DT tracbar. Same to remove. Then reinstall. http://www.pavementsucks.com/tech/dtbar.php

Here is a thread on it. https://dodgeforum.com/m_94960/tm.htm

 

when yall rotate your tires you always just do them front to back or do you ever do side to side. my right front gets wear on the outside but i was told it wasnt my alignment but the way the roads are made so they drain.

 

I go front to back. The back wears flatter(not turning), and the wear evens out with front from switching. If you only have one front wearing then either there is something worn/out of alignment, you are making harder left turns and digging it in, or the air is low. IMO

 

i rotate mine criss cross (front driver to rear passenger, front passenger to rear driver) if you decide to do that you have to make sure you dont have directional tread though.