Here's a road map for where you want to go:

http://cgi.ebay.com/ebaymotors/BUILD...spagenameZWDVW

 

Hehe yay! Thanks! ... Now gimme some money so I can buy it [sm=bling.gif]

j/k


I'm gonna save it as a fav so that I can refer to it when I need to get a book =D

EDIT: Yall just wait, when i get a 318 stroked to 383 (i think thats it) yall be screaming =D

Thats after i buy the bulletproof tranny from APS, new heads, stroker kit (crank/pistons/rods/etc), 24 lb or so injectors, 52 MM fastman TB, a drive shaft, replace the rearend with 3.92(?) posi lock, bigger brakes (ya know, the whole safety issue), and a nice life insurance policy... with my g/f , mom and sister tacked to it...

Oh yeah ... AND A JOB.. .lol

EDIT2: Oh yeah, I wanna hop this truck up so much that the body twist and raise my truck to the point where for the 1st 60', I'm looking at the sky yo!

 

Any idea on how to get a hot motor to run with our computers?

 

Send the pcm off to either KRC or B&G for a reflash. They both have stroker flashes.

 

From what I read at dto.org, people have claimed to use the regular PCM (5.9) to run their 408 (i think thats correct, its early in the morning for me) .

However I was thinking about buying a block and building it slowly... Just a bare block or even one with good heads on it and intake (I want r/t heads and M1 intake/Kegger =D).. And I know that my pcm would prolly not like the 349 or 390... (depends on what I want to stroke it out at)

So I was thinking about doing this http://www.bgchrysler.com/Service/Hi...b_g_flash.html Having them reprogram a used PCM to go with the motor...

Then again if i can find a sweet deal on a 360 bare block, I'm so going for it... (i'm talking like 300 bucks)... I'll spend 500 dollars getting it machined what not and painted...

Yeah, It wont be for like ... 3 years or so... But When I get it started DF will be the first to know... before the g/f... lol

 

This is what a stroker sounds like:
http://www.wb8xx.com/ram/406a.wav

There is a thread in the Dodge section over on pavement sucks started by a guy that just finished one.

 

hey JJ check this out dude!!!



i guess we won that contest of the ingredients!!!!! not sure of the details yet..

 

Really ? Holy ****!

 

no kiddin huh!!!! im gonna PM him and find out what we gotta do

 

found a 318 engine a guy is selling in the paper for 500 bucks.. im seriously thinking about picking it up and tearing it down and building it into 1 hell of a 318 for my truck