2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

spark nock

Old Mar 9, 2007 | 10:05 PM
  #11  
padodgeram's Avatar
padodgeram
Record Breaker
Joined: Jul 2006
Posts: 2,440
Likes: 1
From: PA
Default RE: spark nock

could be just the gas ...or try a colder spark plug ..did you try running 89 ?
 
Reply
Old Mar 9, 2007 | 10:42 PM
  #12  
dhvaughan's Avatar
dhvaughan
Hall Of Fame
Joined: Jul 2006
Posts: 12,204
Likes: 10
From: Gainesville, Ga.
Default RE: spark nock

ORIGINAL: TMS Bill
The pre-ignition can (in some cases) be caused by the increased compression resulting from reduced volume of the CC due to carbon buildup.
hmm, i think i'll just leave mine in there then. cheap performance mod.
 
Reply
Old Mar 9, 2007 | 11:59 PM
  #13  
TMS Bill's Avatar
TMS Bill
Record Breaker
Joined: Jul 2006
Posts: 2,400
Likes: 1
From: Warren, NJ
Default RE: spark nock

Hell yeah ... if it's not pinging ... leave it in there. Of course, some pre-ignition is caused by red hot peaks in the carbon ... kinda like a glow-plug.
 
Reply
Old Mar 10, 2007 | 12:15 PM
  #14  
ja7369's Avatar
ja7369
Thread Starter
Joined: Nov 2006
Posts: 15
Likes: 0
From:
Default RE: spark nock

Well i still have the spark nock, i even ran 92 octane ,,, I may try this process 1 more time , but after that i dont know what to do
 
Reply
Old Mar 10, 2007 | 01:07 PM
  #15  
TPSDODGE's Avatar
TPSDODGE
Professional
Joined: Jan 2005
Posts: 225
Likes: 0
From:
Default RE: spark nock

the mopar stuff is about 6-7 bux it works so much better than seafoam but you have to letit set for 2-3 hours after you spray it in
 
Reply
Old Mar 10, 2007 | 09:47 PM
  #16  
TMS Bill's Avatar
TMS Bill
Record Breaker
Joined: Jul 2006
Posts: 2,400
Likes: 1
From: Warren, NJ
Default RE: spark nock

ORIGINAL: ja7369

Well i still have the spark nock, i even ran 92 octane ,,, I may try this process 1 more time , but after that i dont know what to do
Drop down 1 heat range on your plugs and replace the wires with 8mm or fatter.

You're CERTAIN you did the plenum gasket correctly?
 
Reply


Thread Tools
Search this Thread

All times are GMT -4. The time now is 02:10 PM.