The 05's have a TCM issue with the DSP/Trinity. Turn the key "On" before trying to program the TCM. If I dont do that it doesnt read my TCM

 

tried to do this but still no trans. control
no shift points options under the "modify parameters" menu

 

I know it sucks you are FR and Diablo is over here but I guess the only thing to do is call Mike @ Diablo or get an email from him and go back and forth that way.

 

yeah....I also guess is the only thing to do
I'll try to call them today...

 

Have you tried any other CROM's, I'm running the 9r09, and that works good for my truck.

 

I called Mikel from DS today on the phone and we have proceeded to a "forced TCM calibration update" and guess what ....???
IT WORKED!!!
I can see now displaying the perf trans. tune menu with the following options :
-part throttle upshift
-part throttle downshift
-RPM shift points

Now I just need to set these tunes so if you guys can provide me a settings schedule exemple it would be great !!
and also about the idle RPM in neutral/drive if I have to set this

thanx a lot

 

Someone should make a video on the trans settings

 

Look around page 5 or 6 in this thread, I have a PT up/Down and WOT shift schedule in listed for my 05' should give you a good base to start with. I have since tweaked them a little to make it work better with my gears, TC and cam.

 

THX bud, i will have to look and find it

 

thank you so much Truckin151 !
found your shift schedule in page 22....will try this out tomorrow