Sounds good, that'll be great fun. I'm looking forward to see your numbers.

 

How long until you get the pulls done on the dyno?

 

ill do it next week if anyone wants to donate in the silvers dyno fund lol

 

Just be sure you have everything up to date, fluids etc. before you do the run cause its going to be putting some abuse on it depending how many runs they do.

 

For numbers, you'll have basically the same mods I did when I did my run, so I can see 270-280rwhp and 300-310rwtq, I think I had mine (with just the 3815, cutout, CAI) at 276/301. I need to go do another pass to see where Im at now. $50 here gets me 3 runs.

 

hmm thanks for that. i might need to wait a little bit. i need plugs, and an oil change...

and yea its 3 pulls for 60

 

You guys and these cheap dyno pulls. Now we are going to be expecting numbers from both of you since you can get it done so cheaply.

 

I wont be doing any pulls til after the cam goes in and I get all the head work done (springs/rods upgraded), and it cools down a bit. Last thing I want to do is run down there to do a pull when its 100+ outside

 

You doing the cam swap in your driveway/garage or are you taking it to a shop?

 

One of the guys here has a full shop and lift with all thetools you could think of in his backyard with AC so we'll be doing it there. Trying to see if I can do something else at the same time though too