Electric cutout problems
#1
Electric cutout problems
i installed my electric cutout about 2 months ago now and i went to open it the other day but it wont open, if u get someone to hold the switch to the opening position then crawl under and give it a little push it opens... has anyone had a problem like this befoer?
#4
RE: Electric cutout problems
Try some lithium grease spray or tube. This will work better against the heat. WD-40 is water based and depending on what is actually sprayed can possibly rust any moving parts. If you use WD-40, you will have to use it all the time to keep the rusting and seizing from happening.
#5
RE: Electric cutout problems
ORIGINAL: L and R Two
Try some lithium grease spray or tube. This will work better against the heat. WD-40 is water based and depending on what is actually sprayed can possibly rust any moving parts. If you use WD-40, you will have to use it all the time to keep the rusting and seizing from happening.
Try some lithium grease spray or tube. This will work better against the heat. WD-40 is water based and depending on what is actually sprayed can possibly rust any moving parts. If you use WD-40, you will have to use it all the time to keep the rusting and seizing from happening.
#6
#7
Trending Topics
#8
#9
#10