Mine came on yesterday afternoon, all lights worked, had someone stand behind the truck while I stepped on the brakes and only the right brake light was out, replaced the bulb #3057, ALL WAS FINE.

Takes a "torex" tool (torex screws are on the tailgate side) and a flat tip screwdriver to remove the tail light housing and a phillips screwdriver to remove the bulb.

After removing the tailgate side screws there are two "pins" (which you can not see) on the body side of the tail light housing, use the flat tip screwdriver and GENTLY "pry" the the bodyside of the tail light housing to remove it, the rest is easy.

 

This contributed to a phantom lamp out I was getting every now and then for one of my reverse lights. Once I replaced it all was good.

 

I am having the same problem with my 2003 dodge cc. I have checked all the lights except for the fog lights as mentioned. Every light comes on when it is suppose to.
Scenario:Truck running, lights on,including fogs, flashers on, (lamp out light is on) If I remove bulbs one at a time, will the( lamp out light) go out when I remove the bad bulb? or will it stay on because a bulb is missing?

 

It'll stay on with the bulb missing

 

mine does it also without lights on, without brakes on.....when I can stop and the indicator light stays on........I walk around and all lights work.....
I don't understand how the bulb out circuit works......
?????

 

Step 1
Turn parking lights on and walk around the truck. Are they all on? Go to step 2

Step 2
Turn left signals on and walk around the truck. Are the front and rear working? Go to step 3

Step 3
Turn right signals on and walk around the truck. Are the front and rear working? Go to step 4

Step 4
Turn hazard signals on and walk around the truck. Are they all working? Go to step 5

Step 5
Have someone press the brake for you while you check the tail lights. Are they both working? Go back and do it again because you missed something.

 

My dad's Ram had the same problem. Only it was really bad whenever he hit a bump. I ended up replacing most of the bulbs in both taillights, hasn't been back since. lol

 

I have 120956 miles on my pickup I was running about 65 mph and my oil pressure bottomed out and my truck died I could crank it but when I went to shift gears it would die well I drove another mile to my buddys house and it shut off and hasn't cranked since I replaced the crank position sensor and oil pressure sensor replacing the cam shaft sensor tomorrow morning and hoping it will crank truck still turns over and wants to crank but wont had a fresh oil change right before it happened and just drained all oil and replaced it and oil filter.. If anyone has had this happen before please comment and give advise

 

when I first start my 2003 3500 Ram the lamp out indicator flashes & then the dinging begins. It all goes away after 5 or so minutes but can intermittently return. This is VERY annoying.