great info! thanks
does anyone else have any input on the 50HD flows?

 

Go with Magnaflows. The Flowmasters will rot out in about 5 years. Mine did. Magnaflows flow about twice as much with a nice sound to them, and they are stainless so they won't rust.

 

...you want loud..boy your gonna get it loud...it won't drone..it'll be too loud in the cab to hear it drone...hehe.. can't wait to hear the clip...

 

I tried to get some sound clips up....they didn't turn out the best as I had to use my Macbook Pro to record the sound but take them as you will. All were recorded in parked position outside.

exhaust1.mp3 - 0.29MB

exhaust2.mp3 - 0.23MB

exhaust3.mp3 - 0.20MB

Movie 3.mov - 10.22MB

(this was filmed with my iSight on my laptop because the mic on my camcorder was broken...a little distortion and what not but came out alright I guess. This is just the view from the tailpipe)

When it's light out, I'll take some pictures from underneath. Now I need to decide if I wanna get a tip or not. Guess I should look around.

 

so i got my exhaust done today
i went with a flowmaster 44 muffler and rear resonator delete. Its sounds nice but...it dose'nt seem very loud??? will this change after i "break" it in a bit?
also the MDS drone is "differnt" its a very lowwww growl but not to bad
thanks
-scott

 

well, mine has started to growl a little more now that it's getting broken in. Gotta remember it's a little quieter inside the truck than outside. Plus, if you wanted LOUD then you shoulda gone straight pipes or glasspack. You should have a buddy do a drive by past you so you can hear what others hear. May impress you a little more? The MDS may start to drive you crazy though, I'd look at getting that turned off.