05 ram rough idle stalling at stops! Please Help
#21
#22
#23
air filter/rough idle
i believe the ttps is located on the throttle body, your going to have to unplug it clen the throttle body.. check then to make sure its looking ok.. what about your air filter? new one lately? built up and not sucking through? im out of ideas, just throwing some around lol
#24
rough idle
vacuum leaks are easy to find when your truck is running crappy take a can of carb cleaner and spray it around areas that would possibly have a vacuum leak if you spray it by a vacuum leak your truck will start to idle normal. did this only to find an egr leaking on a van i fixed.
#25
#26
Rough idle tried new gas cap no dice
Ok so i called the dealer, he told me there is not Throttle Position sensor on my dodge ram. Is he correct? I asked him for a new sensor and he said there was no part listing for a 05 5.7L hemi TPS. So I got a gas cap wich did fit tighter and after putting the new one on my old one was a little loose but the idle still drops as I put it in gear or pull up to a stop. Tomorrow (SAT) i am looking over every hose and plastic tube on the truck. I am also going to take off the throttle body and check over everything and clean everything and everywhere. I will post back tomorrow thanks again for everyones ideas.
#29
Cleaned entire throttle body checked plugs
OK i took off the throttle body, cleaned inside and out everywhere i could get my hand into, it was dirty and now it looks brand new. I took out 1 of the plugs and they are a little bad but not harble, I was thinking maybe the plugs where starting to go. I even replaced the PCV valve and I took off the metal hose that goes from the throttle body to the EGR valve and the hose was filthy, so I cleaned out that. I bought plugs and wires and i am going to try to put them on SUN or MON. I also cleaned as far into the area after the throttle body as I could reach. I put a can of dry gas (the red) into the tank I have to run the gas out but that will be this week. I also put my K&N intake back on and finally I drove the truck. No engine lights and I have not gone to far but it ran good, I will run the truck more today. I also will try the key cyle again to see if anyting pops up. I checked all of the hoses that I could reach and everything seemed fine. Today I am going to look over the fuel tank area and all the way up to the engine. I will post back. thanks again for the help, hopefully the pcv valve and the cleaning did the trick.
#30