3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

I need help replacing my mirror (glass)

Thread Tools
 
Search this Thread
 
Old Jun 5, 2013 | 06:05 PM
  #1  
risher2909's Avatar
risher2909
Thread Starter
|
Registered User
Joined: Jun 2013
Posts: 2
Likes: 0
From: Rancho Cucamonga, CA
Default I need help replacing my mirror (glass)

I cant seem to get the glass off of the housing. I have a 2009 ram 1500. The mirror is powered and heated.

suggestions please!!
 
Reply
Old Jun 5, 2013 | 10:10 PM
  #2  
HeyYou's Avatar
HeyYou
Administrator
Veteran: Air Force
Community Favorite
15 Year Member
Community Builder
Joined: Apr 2010
Posts: 87,475
Likes: 4,223
From: Clayton MI
Default

Not sure if you can just replace the glass.... check the third gen ram section for suggestions.

Welcome to DF!
 
Reply
Old Jun 6, 2013 | 01:10 PM
  #3  
jkeaton's Avatar
jkeaton
DF Admin
15 Year Member
Photogenic
Photoriffic
Liked
Joined: Apr 2010
Posts: 28,211
Likes: 366
From: Winston Salem, NC
Default

Welcome to DF! Post your question in the 3rd gen Ram section. They will help you out.
 
Reply
Old Jun 8, 2013 | 12:39 PM
  #4  
Wanderer's Avatar
Wanderer
Veteran
Joined: Feb 2006
Posts: 387
Likes: 0
From: Northern New Jersey
Default

Give this a try, from the 2004 service manual. Good Luck.

REMOVAL
Standard Mirror


(1) Position the mirror glass so that it’s facing in
toward the vehicle as far as possible.
(2) Disengage the rear housing cover retaining
tabs and remove the cover.
(3) Disengage the lower glass retaining tab to
motor.
(4) Slide glass up and remove from motor.
(5) Disconnect the two heated mirror electrical
connectors, if equipped.
Tow Package Mirror
(1) Position the mirror in the out position.
(2) Release the retaining clip and separate the
glass.
(3) Disconnect the four heated glass electrical connectors,
if equipped.


INSTALLATION
Standard Mirror


(1) Connect the two heated mirror electrical connectors,
if equipped.
(2) Position the mirror glass mounting holes over
the four feet of the mirror motor and slide down.
(3) Engage the lower glass retaining tab to the
motor.
(4) Position the rear housing cover and seat the
retaining tabs fully.
 
Reply




All times are GMT -4. The time now is 03:15 AM.