When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
So I have an 04 dodge ram 1500 with a 4.7. I have a lot of bolts that are rusted and stripped out. I had to take the valve covers off to replace both heads. Can anyone tell if I can use just regular bolts instead of buying new valve covers?
As long as you get same thread size an length then you can use a bolt from the hardware store , I would recommend a grade 8 bolt or close to that for replacement
As long as you get same thread size an length then you can use a bolt from the hardware store , I would recommend a grade 8 bolt or close to that for replacement
Grade 8 for a valve cover? That seems like overkill to me.....
it is but why not put in a strong bolt, of course a 5 will do
3 will do as well. Not like they are torqued really tight. And why spend money where you don't need to? If you want expensive bolts, go for stainless steel.