Put in new longblock , I have no codes new cam and crank sencers turns over but no power to coils or injectors

 

Have you check the IPM or TIPM module for any blown fuses? Did the long block come with camshaft and timing already setup? I have seen where a connector under the dash on the driver side would come loose and unplug and that will also cause a no start problem. But these are just guesses without seeing the vehicle.

 

Yes check all fuse checked under fuse box for cracked wires check all grounds

 

Yes check all fuse checked under fuse box for cracked wires check all grounds

 

By any chance did the wire harness get pinched while installing the motor?

 

Thought of that also and no .I don't get that I have no codes

 

So nothing ,no body's got a clue it was just a head gasket motor had 200,000 so thought to put a fresh long block and it been a night mare and from read others this is something that happens often.

 

I'm running out of options, Turn the key on and try to jump the starter relay. If you are not getting any power out to the engine. I'm guessing ignition.