When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Does anybody know if the foam inside a 3500 frame is flammable? or if there is suppose to be foam inside the frame ?
just trying to weld some plates on the outside of the frame until I can get a new frame
Does anybody know if the foam inside a 3500 frame is flammable? or if there is suppose to be foam inside the frame ?
just trying to weld some plates on the outside of the frame until I can get a new frame
I am thinkin' that if you get it hot enough, it'll burn, and likely give off toxic fumes. Welding will certainly get it hot enough......Think I would make an adapter for my garden hose, with a stiff, small diameter pipe, for putting out fires inside frame rails, before getting started.
Lol yeah I know I need to be ready but did these frames come with foam inside them from the factory or did some dumb *** put it in there to sell the truck
No clue on that. It *might* be factory, and was used to dampen vibrations/quiet the ride...... The factory doesn't consider rust repair when they are rolling off the floor.
2005 Dodge Ram frame repair
