How do you guys keep bags, groceries, etc from sliding down the bed
#11
#14
There are 2 slots - 1 on each side just behind the wheel wells (the tailgate side) in the bed. Just cut a 2x8 to length and notch the lower corners to allow for the raidius roll of the bed floor to the sides and just drop it in the slots. Viola! (pronounced waa-la), now you have a divider to keep your smaller goodies from rolling around your truck bed and you only spent $8.00 on the 2x8 and it's easliy removable. No holes to drill or confusing directions.
Just send in $20 for detailed instructions - Operators are standing by. LOL
Just send in $20 for detailed instructions - Operators are standing by. LOL
#15
This might be your ticket.
http://www.autotrucktoys.com/ram/Mop...P5047C993.aspx
Thats just one. Surf around for price.
I have used one of these for 12 years. Adds 2' when folded out.
http://www.autotrucktoys.com/ram/Mop...P5047C993.aspx
Thats just one. Surf around for price.
I have used one of these for 12 years. Adds 2' when folded out.
#16
Hey,
The bed extender pivot point is made in a way that locks it down when forward or when on the tail gate.
To remove it. Rotate the bed extender until its sitting up....1/2 way. Not sitting on the bed or gate. You lift it right off.
Slides in and out when in that positon.
The pivot point is enginnered just for that. Its a slot that is open at the top..really a "V" shaped opening. Will only come off the pivot in that position. Down either way locks it in.
Taking it off takes about 15 seconds.
It comes with instructions better than this.
Yes, taking it off is a snap...so is reinstalling it. Its light...aluminum tubes.
Cheers
Blue
The bed extender pivot point is made in a way that locks it down when forward or when on the tail gate.
To remove it. Rotate the bed extender until its sitting up....1/2 way. Not sitting on the bed or gate. You lift it right off.
Slides in and out when in that positon.
The pivot point is enginnered just for that. Its a slot that is open at the top..really a "V" shaped opening. Will only come off the pivot in that position. Down either way locks it in.
Taking it off takes about 15 seconds.
It comes with instructions better than this.
Yes, taking it off is a snap...so is reinstalling it. Its light...aluminum tubes.
Cheers
Blue
#19
#20