I recently installed the recon reverse lights on my truck, and im not getting power to them when i put the truck in reverse. the toggle switch works only. i have a relay, that i think is bad, But my questions is. If i splice into the reverse wires ( white with a red stripe) i should get power uh? I know some splice into the 7 pin wiring harness for stuff like this, but i have done it already.

 

check your fuse box first for blown fuse

 

my reverse lights still work from the factory, when in reverse

 

yeah you should get power, and its on a separate fuse than the 7 pin, I would use the 7 pin.

 

will the wiring schematic for the plug help?

http://moparestore.trademotion.com/m...s/K6869558.pdf

it's at the bottom of the PDF
good luck

(nevermind, it does not have the brake lights listed, lo siento)

 

I have it working, Thanks for the help

 

What was the fix?

 

I had the diao the wrong way. The picture showed one way, but instructions said a different way and i had everything sealed and taped, so i had to un tap eveything