At 12000miles. Can anyone tell me how to check the code??? i don't have a code reader

 

With the truck off, insert the key, turn to the ON position (NOT START) 3 times. On the third time, leave it in the ON position. The 'P'code will show in the digital read out portion of your dash. Once you know what the P-code is you will have to find out what it means. I think there is a list on this site somewhere. Good luck.

 

All the codes are right up at the top in the stickies. Look in the DIY thread and there is a compiled list.

 

thanks guys!!!!

 

Code P2262- Turbo boost not detected.

I guess i'll be going by the dealer today!!!! I know they are gonna try and say something about my aftermarket CAI or Exhaust!!!!!! Wish me luck

 

Wait, wait, wait. Check the MAP sensor connection before you go to the dealer. It should be right near the intake horn, behind and down a few inches. Also, check the waste gate connection from the turbo itself. The wire should be below the turbo and runs slightly to the front. It may just be a loose connection.

 

Yes check that!! Did you jack with your intake at all? Even with the truck not running, if you disconnect those connections or disturb them, it will throw a code.

 

I haven't messed with the intake or exhaust since i replaced em back in Febuary. There is a TSB out for that code, so hopefully that is all it is!!!!!

I'll check em before i take her down tho

 

Mine goes in Thursday for the same code. I haven't touched my engine one bit but will double check those connections tonight. But I also have a ball joint boot torn that comes off my pitman arm so they'll have to fix that if anything.

 

Its my intake and exhaust!!!!!

They are saying...and i Quote!!!!!!! " Modified exhaust will not allow enought backpressure, therefore the system will not perform right!!!!"
And they charged me 115.00!!!!! Kinda funny that there is a TSB out for that code!!!!